starjammir
Hard-core CEG'er
Like I said on the phone man, check the spark plug wires to make sure they are correct.
Like I said on the phone man, check the spark plug wires to make sure they are correct.
Injectors all plugs in? All I can think of is fuel pressure and such. Even if it has bad gas with the good gas, it should still run...just poorly.
Injectors all plugs in? All I can think of is fuel pressure and such. Even if it has bad gas with the good gas, it should still run...just poorly.
YesDo you have an ohm meter?
Yes, Its supposed to be 12volts?Can you check the voltage from your coilpack?
Nope not sure, all the gaskets are brand new..but how would i check?Are you sure you don't have a vacume leak either????
Ok, I'll do it again, but like i said the top 2 were snug, the bottom one moved a bit and clicked it in.If I were you, I would disconnect all 3 main harnesses and reconnect them with some large pliars until you hear them click. I know you already checked this, but I would do it for the peace of mind that you know they are on there tight. Tin plated connectors need a pretty high normal force compared to gold plating to get a good electrical connection.
Yes, it is on there good. I took all the wires off today and reseated them back on, making sure they where connected good. both on the coil and sparkplugsNext, is the coil pack ground wire secured? It's any easy thing to forget. I'm sure whatever it is, its something simple. Check all your spark plug wires. One may not be getting a good connection. Unplug them and replug them until you know have a good connection.
I had that issue, see my post here:After that, I think I pull the UIM and check the injector harness wiring. You've got a 98. The harnesses are prone to cracking. You may have an injector thats arching and running full duty. I had this issue with my 96 and two injectors were arching.
Thery where when i put the timing cover back on, unless they jumped or something when i did the flywheel :S Do these symptoms sound like a pulse wheel off or a mistiming????Are you absolutely positive the cams were timed correctly?
I have been..... if i do it much more I'm going to have the buy a new ing starter!!i would just get it to run/sputter/backfire, and keep it running as long as possible haha
maybe you just need to clear some old out.
I'll take it for free.