JJames
CEG'er
...Betcha he got V6 springs. I'm sure I did. Hopefully I can change those out at some point, and also get the correct strut tower bolts :nonono:. Hey OP, check to see if there is a gap between the strut tower bolt rubber boot and the strut tower (inside the engine bay). I guarantee there is a gap.
The springs in the rear are the same whether it is a 4 or a 6 cylinder. Read the above post. I just checked and from 95 - 00 the rear springs are the same part number. The rear stuts also seem to be the same.
To the OP, it is most likely install error. Either the springs didn't seat correctly, or top bolt didn't get tightened down all the way. Take it back to the shop that worked on it and tell them that it rides worse than before you brought it there. I am sure they will gladly look at it again.
Last edited: