aboythatskates
Hard-core CEG'er
2 days ago · #1
I am designing a tubular control arm for the front for my car. And I figure out ask you guys maybe I can make a few sets if there is enough interest.
I've been debating between 2 designs.
Option 1: Stangkiller design with the factory ball joint attached to knuckle. And 2 rod ends on the inside.
Or
option 2: rod end on the outside also. This would require a rod end to knuckle taper adapter to be machined.
Anyone? I'm thinking about 5 sets
I am designing a tubular control arm for the front for my car. And I figure out ask you guys maybe I can make a few sets if there is enough interest.
I've been debating between 2 designs.
Option 1: Stangkiller design with the factory ball joint attached to knuckle. And 2 rod ends on the inside.
Or
option 2: rod end on the outside also. This would require a rod end to knuckle taper adapter to be machined.
Anyone? I'm thinking about 5 sets