Ok, so I've got a PKF1 for my 99 Contour from http://bypasskit.com/product.aspx?prodid=PKF1
I have hooked it up as follows:
On Module On Car
TX: White/Green
RX: Gray/Orange
GND: Black/Green
IGN 12V: Green/Black
When I "program the module", with my PATS key, then use my non-PATS key to start the car, it works fine. Then, I'll turn the car off, and wait until the PATS system is activated and try it again. Only this time, my non-PATS key will not work, unless I reprogram the module again.
It's as if the PKF1 module is not saving the correct information from the PATS key when the system is disengaged.
Any suggestions?
I have hooked it up as follows:
On Module On Car
TX: White/Green
RX: Gray/Orange
GND: Black/Green
IGN 12V: Green/Black
When I "program the module", with my PATS key, then use my non-PATS key to start the car, it works fine. Then, I'll turn the car off, and wait until the PATS system is activated and try it again. Only this time, my non-PATS key will not work, unless I reprogram the module again.
It's as if the PKF1 module is not saving the correct information from the PATS key when the system is disengaged.
Any suggestions?