CSVT#49
Addicted CEG'er
To do this right you would need...
-fenders
-headlights... might as well spring for the morettes at this point
-hood
-grill
-ST bumper
-ST bumper support
-ST bumper fascia
You would have a mismatch in body lines, but you could work this kink out (I think) by fabbing the fenders to have the body line continue into them and end at the fender well. This project will be very, very expensive. You might as well look at some of the body kits that are available for the Mondeo's too. Some of them look pretty wild and a lot better then the factory ST look IMO.
-fenders
-headlights... might as well spring for the morettes at this point
-hood
-grill
-ST bumper
-ST bumper support
-ST bumper fascia
You would have a mismatch in body lines, but you could work this kink out (I think) by fabbing the fenders to have the body line continue into them and end at the fender well. This project will be very, very expensive. You might as well look at some of the body kits that are available for the Mondeo's too. Some of them look pretty wild and a lot better then the factory ST look IMO.