TK95Contour
CEG'er
Im in the middle of doing a major swap to my 95 SE. I need to : replace engine, replace all underhood harness's and replace the clutch , and slave cylinder. I was wondering if i could drop the whole subframe with everything all together? I wanted to know the easiest way to pull everything without getting to lost. This is my first motor/trans swap and im so ready to back out.
I have most of the wiring/sensors and hoses disconnected. I have the upper intake off, sway bar endlinks are off, y-pipe is off..
Im starting to get really lost as far as what to start on next. Im basicaly doing this alone with basic handtools in a garage. I have the ford service manual and have been trying to do it step by step but im starting to think im in over my head.
Please help!!! :help:
Any additional info anybody could give me on the best way to go on with this please chime in!
I have most of the wiring/sensors and hoses disconnected. I have the upper intake off, sway bar endlinks are off, y-pipe is off..
Im starting to get really lost as far as what to start on next. Im basicaly doing this alone with basic handtools in a garage. I have the ford service manual and have been trying to do it step by step but im starting to think im in over my head.
Please help!!! :help:
Any additional info anybody could give me on the best way to go on with this please chime in!