pulled the parts today and this is pretty much only a good idea for a 97. parts needed are fuel door( if you can not get in the trunk this isn't a problem, remove the screw that hold on the gas cap and remove the gas cap, then twist the round part that houses the latch and it will pop out it is connected in the trunk so you will have to bust it to get the other parts out intact, then simply pry gently behind the top of the seal that surrounds the fuel door housing and there is a metal peice you push down then pry out around the edges) Then you will have to get the other parts from another donor. You will need the door and housing intact or not it can be changed to another housing easily if needed. then you will need plastic housing in the trunk that the cable goes through, the latch for the fuel door, the plastic housing for the latch and the release from near the driver's seat. NOW WHY THIS WON'T WORK FOR THE 98+ there is a peice of metal that hold both the mechanism that the cable goes through and the latch for the fuel door and removing this from the donor car would require cut out the rear fender and grind down this bracket then spot weld or adhere it to the fender inside your own tour. to put this on the 97's a hole will have to be drilled for the latch to go through. on the other hand a good way to get the look without all the troubles is to simply use the flat door inside your original housing and simply use the little plastic peice that plugs into the non-pop latch. then the door can still be easily opened with a tiny metal pry that can be put on your keys.