TribalTour
CEG'er
Can it be done? if so how laborious?
its been done look around a littleCan it be done? if so how laborious?
its been done look around a little
Its been done quite a few times. The rear bumper and sideskirts are a direct swap, but the SVT front bumper will need to be cut and molded into a pre 98 bumper.
just use some duct tape :shrug: it's pretty simple.
What do you mean about the front? is it difficult to DIY?
You take your pre 98 bumper off, cut it in half, lay it on top of the SVT bumper, then cut the SVT wherever the pre 98 meets. so once you are done cutting, the pre 98 and SVT match up...if that makes sense.
After that, thats where the duct tape comes in :laugh:
There was a detailed post by rkneeshaw a while back about the entire process but i can't find it.
I was kind of afraid of that. do you know what is recommended to mold the two together?
Yah, ryan told me what is happening with his car. Sad really, and too bad I don't need any parts or I would pick up that front bumper atleast.....