Ft.WorthSVT
CEG'er
I was wondering if anyone could help me find the installation process for the sub frame install. I cant seem to find it. Thanks
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
Sub frame installation?
- Thread starter Ft.WorthSVT
- Start date
muntus
Veteran CEG'er
Front or rear?
Ft.WorthSVT
CEG'er
Iam sorry i meant the sub frame connectors.
http://www.contour.org/ubbthreads/s...mber=1110249&page=&view=&sb=5&o=&fpart=1&vc=1
Pictures are above and below is the install instructions:
As posted by svt4stv:
"the install is very basic.
put the car on a drive on lift only! to avoid pre-loading the suspension.
using the pics i posted of my own car (see the link I gave you above ^) the installer can easily see where they go. they pretty much line up. there are not exact points for them to go. there is room to play.
*if youre bored, jack up the car and get under there to see where it lines up. the part where the front and rear bars meet (welded together to form a "v") point outward, towards the outside of the car. the stepped up part goes in the rear. youll see on the body where to line them up. that stepped up part goes up, just aft of where the flat underside of the body ends. check out my pics again that i posted. i suggest you print these pics out in color to give to your installer. its more than i had."
Pictures are above and below is the install instructions:
As posted by svt4stv:
"the install is very basic.
put the car on a drive on lift only! to avoid pre-loading the suspension.
using the pics i posted of my own car (see the link I gave you above ^) the installer can easily see where they go. they pretty much line up. there are not exact points for them to go. there is room to play.
*if youre bored, jack up the car and get under there to see where it lines up. the part where the front and rear bars meet (welded together to form a "v") point outward, towards the outside of the car. the stepped up part goes in the rear. youll see on the body where to line them up. that stepped up part goes up, just aft of where the flat underside of the body ends. check out my pics again that i posted. i suggest you print these pics out in color to give to your installer. its more than i had."
Last edited:
biminiLX
Hard-core CEG'er
Christine:
Thanks for that link. When I searched SFCs I never found good install pics.
-J
Thanks for that link. When I searched SFCs I never found good install pics.
-J