folks, my csvt came with a silencer security systems alarm, either a 5900p, 6900p, 6905p, or 6909p. i'm trying to figure out how to reprogram it so it stops honking when i arm or disarm it. the manual says it's doable but the dealer has to do it. i don't want to have the dealer do it and i've searched online and can't figure out how to do it myself. has anyone here reprogrammed the silencer alarm before?
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
silencer alarm programming
- Thread starter infratl
- Start date
CarpePoon
Hard-core CEG'er
Are you talking about Valet mode? or you just don't want the arm/disarm chirps? There are a few systems where the dealer simply will plug the control module "brain" into a computer to program it and activate a chirp delete. Its been a few years since I've worked with alarms, but try this. Alot of alarms will always give you the visual confirmation (lights flashing), but will only give audio confirmation (chirp/horn) depending on how the remote button is pressed. If you press it quickly .5 sec or less. you get visual and audio. but if you hold it down for say 1-1.5 sec. you will only get visual and no audio.
Not talking about Valet mode.. I don't want the arm/disarm chirps. I need to activate the chirp delete on it without going to the dealer.. 
.. i'll try the hold for 1-1.5 sec trick tonight to see if it arms/disarms without audio/chirp.. i'll report the results in the morning
.. i'll try the hold for 1-1.5 sec trick tonight to see if it arms/disarms without audio/chirp.. i'll report the results in the morningok, so i tried holding the lock and unlock buttons for 1-1.5 secs but the alarm arms/disarms right when i press the button and it chirps. so, that trick didn't work for this alarm system. i think there may be some jumper settings on the alarm module but i have no clue if that's the case. any ideas?