show pics of your SZ projects

[ryanblacksvt]

Ok now I have projects.

Get and install mirko skidplate
Install stage 2 axle's
Find a pre-98 trunk lid,get it painted and installed
Find a trailer to tow the 3l turbo to sz08

Just ordered fiberglas eyebrows, I will need to get them painted before sz.

 

[blu_fuz]

Now I have even more options of cool stuff to get done for spring zing....

 

[striker2]

Now I have even more options of cool stuff to get done for spring zing....
http://i49.photobucket.com/albums/f253/blu_fuz/car233.jpg

yeah, like my heat shield.

 

[blu_fuz]

yeah, like my heat shield.

I didn't get it yet....

 

[BrApple]

updated ...

no pics at the moment but items to install

For the SeVT

• NPG big brake kit
• Innovate LC-1 wide band O2 controller
• Skunkworks Battery Relocation Kit (done)
• Autometer Water Temp guage sending unit (done)
• HMS build MTX (installed)
• HMS keyed shift tower (need to install)
• Spec Stage 3+ clutch (installed)
• NPG Turbo Kit (waiting to install)

and if I can't get the SeVT ready in time for SZ I will bring the SVT. It needs the following installed

• Steeda Tri-ax shifter or B&M (B&M installed for now)
• Lo-tek Guage Pod w/Autometer Phantom A/F, Oil Pressure and Voltage guages (needs to be wired up)
• Mirko Splitter and skidplate
• Factory add on alarm (started)
• like to send shift tower out to be keyed by HMS
• like to get an oil filter relocation kit.

and both vehicles will get a full detail in the spring when it warms up using Zaino and the Porter Cable I got for christmas

So since I made up this list the SeVT got a 3L and braided steel lines for the remote oil filter ... and I am getting the Samco hose kit.

Also I need to re-run my amp power wire and install the cap that I have.


3L

Battery Relocation

Stage 3+ clutch

Braidsteel lines for remote oil filter