Hello again.
I need to change 3 shims for my MTX75 since I'm replacing the input/output/diff. bearings and the races that are pressed into the housing. On one side of the trans(side where throwout bearing is) I found 3 shims afer pulling the bearning races apart.
Anyone know what size I would need? They measure under 2mm but they might be worn. The dealer has a shim kit which comes with different sizes.(1.7mm +)
What is the best way to check for proper shimming or bearing preload?
Thanks
I need to change 3 shims for my MTX75 since I'm replacing the input/output/diff. bearings and the races that are pressed into the housing. On one side of the trans(side where throwout bearing is) I found 3 shims afer pulling the bearning races apart.
Anyone know what size I would need? They measure under 2mm but they might be worn. The dealer has a shim kit which comes with different sizes.(1.7mm +)
What is the best way to check for proper shimming or bearing preload?
Thanks