Plate made by Bugzuki anyone installed heads with them?

[tasso]

I am just wondering if anyone has installed these plates and if so how you did it? I am a little apprehensive about using them the way he recommends with high temp silicone.

http://contour.org/ceg-vb/showthread.php?t=8530

 

[todras]

They are a quality piece. Haven't seen them installed yet.

 

[SVTJON87]

high temp silicon is fine, the RTV stuff is used on the valve cover standard. so it will hold up.

 

[TheMexicanJob]

didn't reebs have a set of those. I remember seeing those, or something close to them, at our BWW's meet.

 

[stilov]

I will be putting them on mine...my epoxy came loose...luckily I had silicone on the gaskets that suspended the pieces of epoxy.

Hopefully will get them on this weekend.

 

[svtkev]

i used mine and they worked awesome , what i did was i bought a roll of gasket material (ace hardware online)and sandwiched in between two plates bolted the plates together and just cut it out ,install the gasket you cut , the plate, new lim gasket , and lim. definitely get three so you have one for porting because it does wear the edges of the plate a bit , that way you have two fresh plates for the intake

 

[Reebs]

didn't reebs have a set of those. I remember seeing those, or something close to them, at our BWW's meet.

Yes, those were a set that I bought from bugzuki. They are high quality stuff, and silicone is fine when installing them on the heads.

 

[TheMexicanJob]

Yes, those were a set that I bought from bugzuki. They are high quality stuff, and silicone is fine when installing them on the heads.

i remember checkin em out, they looked to be top notch.