I pulled out the harness for the injectors to replace the ends so I could use 24lb injectors. I put it all back together and it would not start. So I looked at the crank position sensor wiring and it was missing insulation. So I replaced the end and it still won't start. So I pulled the spark plug from cylinder 6 and grounded it as someone else turned the key. No spark. So I thought maybe I created a break in the wiring harness when I took it out before. So I removed the whole harness and checked it pin by pin and it all checked out fine. Put it all back together and was sure to use pliers to lock in the three connectors in the back of the motor. Still no spark. Looking for ideas.
-Mark
-Mark