my98SVTturbo
Hard-core CEG'er
what is a good way to remove those black little caps that cover the torx screws that hold the MAF down? thanks
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
MAF help!
- Thread starter my98SVTturbo
- Start date
zorrex
Enjoys the Abuse
It might be in vain. The torx screws require security bits with holes in the middle. At least they do on my car, and I think it's the same for your SVT. You can just remove the entire MAF assembly and spray clean it rather than cleaning it manually.
95pgt-t
Hard-core CEG'er
you need to melt that platic out,use a lighter or a heat gun.
oh,david..forgot to tell you,that maf electronics i gave you is from my car,never had a cel so its golden to use.
oh,david..forgot to tell you,that maf electronics i gave you is from my car,never had a cel so its golden to use.
my98SVTturbo
Hard-core CEG'er
you need to melt that platic out,use a lighter or a heat gun.
oh,david..forgot to tell you,that maf electronics i gave you is from my car,never had a cel so its golden to use.
its alex and the black part was off of your car and works good?
95pgt-t
Hard-core CEG'er
well,who the hell is david..lol. every package i get from your place says david..lol.
yeah,its from my car..i currently have your filthy one on my car
yeah,its from my car..i currently have your filthy one on my car
just take a grinder to the screws and cut a slot in them for a flat blade screw driver. and you don't want to mess with the sensor or the housing ....
CSVT1214
Addicted CEG'er
well,who the hell is david..lol. every package i get from your place says david..lol.
yeah,its from my car..i currently have your filthy one on my car
I think it's his pops. I always have to remember to change the name to Alex when I ship something over because PayPal says David.
2X95SEs
CEG'er
I used vise grips to remove the one with the plastic in it. I had an extra MAF I bought from a friend so I used the other screw from it. You can buy the security torx driver (a muti bit tool) at an electrical supply house.