Input: What do you think???

[svttouruofl]

Well I got extremely bored today in class and started drawing up my system setup. I am going to build a wall and mount everything in it. The amp on the left is a Profile California Series AP700M while the one on the right is also a California Series but it is the AP400. The sub that I'm going to run is a 12" Kicker CompVR 4ohm DVC. I haven't chose a capacitor yet so that is why the spot on the far right is blank still. I am going to flush mount(countersink) everything and the amps will be fan cooled from behind. I have everything but the cap...just trying to figure out the setup. Let me know what you think.

Also if anyone has any suggestions for a capacitor that would somewhat match the color scheme that would be great.

 

[s.rich06]

looks good to me. My only concern was that you are going to run to amps on one 12" kicker?

 

[IRingTwyce]

Maybe one amp is for the door speakers? But mounted there for symmetry's sake?

 

[svttouruofl]

Maybe one amp is for the door speakers? But mounted there for symmetry's sake?

Well not exactly, but the smaller amp is not pushing the Kicker. The larger amp will be sending 350watts rms to the sub at a 2 ohm load. The other amp is used to push my 6 1/2" sub that I have mounted in the rear deck to handle the mids. It also pushes a set of aura bass shakers that are mounted in under the two front seats. I have a high power Panasonic HU that pushes the door speakers with 31 watts rms a channel. I'm just adding the sub to extend my low end and give me more depth.