formulad3
CEG'er
so. after my much unplanned for motor swap. i take my car to get an alignment and when i pick it up i noticed it didnt seem to be running right. lacking power and idling slightly rough. not thinking much of i drive home and after showering quickly and heading out to shop the radio cuts out and i get this noise through the speakers that seems to go with the rpms. then my fuel pressure gage goes crazy and starts showing 100plus psi. then my abs, brake and alternator light comes on. i pull over, shut her down and restart it. seemed fine til about 2 minutes back on road and it happens again. pull over, let her sit for 5 minutes and she was good again. ran ok for 2 days then bam! starts acting up. it seems that if i try to accelerate even in a moderate fashion it happens. cycle power and its all good.
finally, last night after checking all the grounds and adding a missing one. i take it for a ride and at first it didnt happen but as i was on the home stretch to the shop i decided to test it and i attempted to accelerate and it happened again. only this time the lights went out while cruising at highway speeds.
my side markers were still on b ut no high/low beams. i make it back and cycle power. the low beams started working again but i cant for the life of me get the high beams to work. cant even hear the relay for them.
conclusion. is it possible that the tech performing the alignment accidentally messed up and abs sensor? or is it possibly bad wiring for the lights? im gonna start looking into this tonight when i get done with work and was wondering if anyone else had these same symptoms?
thanks all.
finally, last night after checking all the grounds and adding a missing one. i take it for a ride and at first it didnt happen but as i was on the home stretch to the shop i decided to test it and i attempted to accelerate and it happened again. only this time the lights went out while cruising at highway speeds.
my side markers were still on b ut no high/low beams. i make it back and cycle power. the low beams started working again but i cant for the life of me get the high beams to work. cant even hear the relay for them.
conclusion. is it possible that the tech performing the alignment accidentally messed up and abs sensor? or is it possibly bad wiring for the lights? im gonna start looking into this tonight when i get done with work and was wondering if anyone else had these same symptoms?
thanks all.