Icefury
Veteran CEG'er
Have not had a chance to install mine yet, but will have it done in the next few weeks before SZ.
-
Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.
You can register to join the community.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
GROUP BUY: Lower Intake Manifold big bore.
- Thread starter svtfixer
- Start date
- Status
- Not open for further replies.
ScottyDsntKnow
Veteran CEG'er
Out of curiosity, has anyone done a back to back dyno comparison for this mod?
biminiLX
Hard-core CEG'er
Not on these, too early.
The older similar Sho Shop LIMs did have dyno gains posted somewhere in the old forums, I think it was 5-10hp.
Would complement a honed UIM, CAI, exhaust to make a hot 2.5.
-J
The older similar Sho Shop LIMs did have dyno gains posted somewhere in the old forums, I think it was 5-10hp.
Would complement a honed UIM, CAI, exhaust to make a hot 2.5.
-J
Icefury
Veteran CEG'er
Will be installing the big bore LIM today, have not bee feeling well latley so dont know if I'll finish it today. I will post the results soon.
Icefury
Veteran CEG'er
Got the big bore installed. No "official" dyno numbers, but definitely a noticeable increase in the TQ curve. It pulls hard(er)! I have a catch can routed into my PCV system so my UIM/LIM had very little fouling. In short, the cleaning of the IM's played little if any into the increase in TQ.
Anyone else got there's installed yet?
Anyone else got there's installed yet?
- Status
- Not open for further replies.