Dyno'd my 77 Mustang Last Night

[JoeM]

Mods:

302-T5 Tranny
Longtubes, Flowmaster Dunps

302 build is unknown. I bought it, and since the Bearings were still tight i dropped it in the car.


Unknows Cam, Heads Block (other than its a 302)
Weiand 8020 Intake 600 CFM Holly Carb (which i believe i need a 650)
this wasa 4th Gear pull.
Car pulled to 5400 RPM and when shut down was @ 134 MPH.

 

[steelblueSE]

I'm don't know a whole lot about 302's, but if they'll work with a carb, you should add some gt40 heads and intake. My budy added them to his 87GT and with headers x pipe and a tune he put down 264rwhp and 301rwtq.
Not a bad baseline, but there is easily more power to be had.

 

[TourEnvy]

I have gt-40 cast iron heads, with bigger intake valves and milled .40. See my times below.

 

[JoeM]

I have gt-40 cast iron heads, with bigger intake valves and milled .40. See my times below.

Nice times!

What cam/intake/carb?

 

[elraido]

I have gt-40 cast iron heads, with bigger intake valves and milled .40. See my times below.

So, if a 302 can do that what can a 460 with some work do? :crazy:

 

[Redlineracer12]

So, if a 302 can do that what can a 460 with some work do? :crazy:

Anything there's a local guy down here who's in the 9s with his 460 Stang

 

[TheMexicanJob]

i made 202whp and 279 wtq on my 89 302 with EFI

 

[elraido]

Anything there's a local guy down here who's in the 9s with his 460 Stang

Sweet goonga moonga. The truck doesn't need an engine. LOL. Hate to see a near mint body go to waste. Maybe I will just supe the truck up LOL.

 

[TourEnvy]

Nice times!

What cam/intake/carb?

B-cam 1.7's, Wiend Stealth and a 750 dp

 

[Hightower GT]

I never though the day would come where someone on CEG was bragging about their Mustang II.

 

[JoeM]

:shrug:


I paid 600 for a running motor that put down 220 hp with out any tinkering. Ive got more timing and and i can still throw more fuel at it.

Besides, i bragged about my 3L Dyno first... :crazy: