I'm curious if anyone knows what the parts manifest should be for the dash warpage repair kit and if anyone has part numbers for the manifest, I recently purchased the kit from Ford and it came in a large 2"x10"x6' box which contained 1 bag of 15 small rivets, 1 bag of 8 large rivets and 1 bag containing a new defroster venting, defrost vent cover and a 6' long piece of edge trim molding and that is all it came with.
Now, the Attachment III documentation for dash warpage recall calls for the use of U-Clips and Retainers during the installation of the vent and vent cover, and according to the text in the documentation the parts should be included in the kit, problem is when I went back to the Ford dealer they couldn't verify whether or not the parts should have been in the kit and what the part numbers for the U clips and retainers were.
Notes from the documentation...
"Install the U-clips as follows (see Figure 9):
• Obtain the necessary U-clips from the repair kit. Using segmented U-clips, bend them
slightly to match the curve of the defroster duct opening. Installing U-clips in the outermost
defroster duct openings, make sure to install them flush against the opening support as
indicated in View A."
"20. Install one (1) retainer clip into each of the three (3) defroster duct opening supports with holes.
See Figure 12."
Any help would be GREATLY appreciated; I don't want to revisit this warpage again and really don't want to proceed with the install without these clips.
Now, the Attachment III documentation for dash warpage recall calls for the use of U-Clips and Retainers during the installation of the vent and vent cover, and according to the text in the documentation the parts should be included in the kit, problem is when I went back to the Ford dealer they couldn't verify whether or not the parts should have been in the kit and what the part numbers for the U clips and retainers were.
Notes from the documentation...
"Install the U-clips as follows (see Figure 9):
• Obtain the necessary U-clips from the repair kit. Using segmented U-clips, bend them
slightly to match the curve of the defroster duct opening. Installing U-clips in the outermost
defroster duct openings, make sure to install them flush against the opening support as
indicated in View A."
"20. Install one (1) retainer clip into each of the three (3) defroster duct opening supports with holes.
See Figure 12."
Any help would be GREATLY appreciated; I don't want to revisit this warpage again and really don't want to proceed with the install without these clips.