• Welcome to the Contour Enthusiasts Group, the best resource for the Ford Contour and Mercury Mystique.

    You can register to join the community.

Chronicaling the rebuild of an E0

So while scrounging around the jy's today like a ltitle rat looking for some mystique rear domes, I found this little beauty.

I can't tell if it's a B&M or not as it looks different than the B&M I have in my other car. And it is alot shorter and better made than the FRP/Steeda Tri-Ax that I just put in yesterday.

Anyone got an ID on this little sucker?

DSCF1443.jpg
 
maybe it is then and the one on mine really isn't a B&M. Or I'm just losing my mind and it's been too long since I've seen that car that I'm forgetting.
 
Last edited:
great work so far man. good to see a rebuild. I hopefully will have another soon. I've been looking at a local t-red and silfro. don't see any tropics though.
 
So many other people have pictures of themselves in the engine bay, so why not me?

DSCF1459.jpg


Ahh, come to me



DSCF1460.jpg



uggh, I am sooo tired. Time 4 bed
 
69Boss302 said:
So while scrounging around the jy's today like a ltitle rat looking for some mystique rear domes, I found this little beauty.

I can't tell if it's a B&M or not as it looks different than the B&M I have in my other car. And it is alot shorter and better made than the FRP/Steeda Tri-Ax that I just put in yesterday.

Anyone got an ID on this little sucker?

DSCF1443.jpg
Click to expand...

Looks like a B&M Knock off.
 
well. it's about 1.5" x 6" and slightly greenish. It's shallow enough but I need to do some mods to the roof or support. I wish I had a welder here.
Maybe some epoxy would work? And the best part is, I got the sheet aluminum for free today.

And I got some plastic for free too to that I cut out a riser for the shifter. I think it's a bit too thick though because now the shifter hits the shift tower.

I really need to get the headliner out in one piece tomorrow.
 
69Boss302 said:
well. it's about 1.5" x 6" and slightly greenish. It's shallow enough but I need to do some mods to the roof or support. I wish I had a welder here.
Maybe some epoxy would work? And the best part is, I got the sheet aluminum for free today.

And I got some plastic for free too to that I cut out a riser for the shifter. I think it's a bit too thick though because now the shifter hits the shift tower.

I really need to get the headliner out in one piece tomorrow.
Click to expand...
:confused:
 
69Boss302 said:
well. it's about 1.5" x 6" and slightly greenish. It's shallow enough but I need to do some mods to the roof or support. I wish I had a welder here.
Maybe some epoxy would work? And the best part is, I got the sheet aluminum for free today.

And I got some plastic for free too to that I cut out a riser for the shifter. I think it's a bit too thick though because now the shifter hits the shift tower.

I really need to get the headliner out in one piece tomorrow.
Click to expand...

is it a glass slider?
 
You must log in or register to reply here.
Back
Top