Zetec gauge routing

[contourspd98]

I am looking at installing a water, oil pres., volt gauges in a a-pod. I was wondering where it is that I could put all my connections at on my motor. I'm gonna get all mechanical gauges.(I want the real reading) I've looked at the motor and don't know where I can install them at.

Any info is greatly appreciated.

 

[striker2]

Volt meter you can just tap into the ignition wire or any "hot in run" wire under the dash.

for the oil pressure gauge there is a T40 torx head plug in the firewall side of the block about an inch in front of the starter. there is just enough room for the fittings.

im not sure where the best place for the coolant temp would be.

 

[devanmc]

for coolant, their are 2 senders in the plasic housing, the bottom one under the upper hose is for the gauge cluster. You can put you temp gauge their.