Dr. Cross
CEG'er
I had a MIL eliminator (plug-and-play type from Dallas Mustang) failure recently, and when checking the second one I discovered that only 3 pins have continuity from one side of the eliminator to the other. The 4th pin doesn't seem to be connected. Since my other one failed, I have nothing to compare the "good" one to. Does anybody recall if all 4 pins should be continuous? Anyone have an extra one sitting around that they could check?
Maybe the pin in question is the one connected to the resistor in this pic:
I need to verify that there is some resistance on that pin....
Maybe the pin in question is the one connected to the resistor in this pic:
I need to verify that there is some resistance on that pin....
Last edited: