gdk771
New CEG'er
I am attempting to replace the manual shift knob on my ZTech Contour 5 speed but can't get the *#% knob to budge. The entire shift lever wants to twist with it and I am afraid I am going to break something in the base of my shift column if I force it. Is there some sort of trick to this? I don't see where the reverse lockout ring would interfere with it coming off as it is underneath the shifter knob but perhaps I am missing something? Any way to keep the shift lever from "turning" with the knob? Is there some sort of locking pin that I need to remove first that I don't see at the base of the knob?
thanks.
thanks.