Hey guys,
I was changing my CV joint after replacing MTX mount and at the same time had to replace the ball joint.
The CV joint was more difficult to install this time and my BJ was finished.
So, I cannot get the new BJ to go into the steering knuckle hole. It is 50 % inside but that is all.
Is it possible tha the axle is not completely inside the transmission?
I don't have MTX fluid leaking. Plus, the hub did rotate and I have both wheels out of alignment.
I don't know to adjust the wheels strait to go to the garage for an alignment.
Thanks,
I was changing my CV joint after replacing MTX mount and at the same time had to replace the ball joint.
The CV joint was more difficult to install this time and my BJ was finished.
So, I cannot get the new BJ to go into the steering knuckle hole. It is 50 % inside but that is all.
Is it possible tha the axle is not completely inside the transmission?
I don't have MTX fluid leaking. Plus, the hub did rotate and I have both wheels out of alignment.
I don't know to adjust the wheels strait to go to the garage for an alignment.
Thanks,