formulad3
CEG'er
Hi all,
I am finishing up converting from one 3l block to another and i
Noticed that the crank end on the flywheel side sticks out roughly
1 inch on new block and the old one appears to be flush???
Do i need to gring/cut that nipple down flush or can it be left alone
Without worries?
Thanks,
Aaron
I am finishing up converting from one 3l block to another and i
Noticed that the crank end on the flywheel side sticks out roughly
1 inch on new block and the old one appears to be flush???
Do i need to gring/cut that nipple down flush or can it be left alone
Without worries?
Thanks,
Aaron