The sway bar mounting bracket that is on the truck could possibly work in this situation. I dont have any measurements, other then just visual (I was looking through a small gap between the snow and the bumper). It is using two metal straps (for lack of a better word) that bolt together around the strut rod creating a loop. The rubber bushing goes inside of that. Right now the other end holds the normal sandwich style sway bar end link, but it could probably be easily removed and tapped to accept a heim joint. It also looks like it is the same height as our factory setup, if not just a tad bit shorter, which would be better for lowered cars.
The Dodge dealer could probably give you exact measurements, just make sure you have them look it up for a 2wd, the 4wd bracket is completely different.
