YA so I have an older ride on its a Roper, with a 400cc 11hp Briggs and Stratton 4 cycle engine, over the past few mows I have been losing power near the end of the mow, and the other day I noticed a small gas leak under the carb, I traced it back to an L shaped rubber tube that hooked on to the carb and into the manifold. it was cracked and the gas would leak out of it. Now I am sure that I can buy a replacement, my problem is this, I had to take the carb off in order to remove the tube when I removed the carb the throttle linkages "two metal rods that hook to the carb and go to my throttle controls" unhook in the process and I have NO clue where each goes? Anyone that could advise I thank in advance.
CC
