**Symptoms
- Car stalled out without missing
- Car wouldn't start up immediately, but did after 10 minutes
- Car effortlessly stalled and fired back up again- while driving- and missed only at this point.
A friend and I worked this out. I rented out an OBD II code reader and ended up with P0320, so I immediately checked the ground and ripped the coil pack off the car.
The surface on the bottom is definately rough with surface rust, so I'm going to clean that up. Here are our ohm readings:
4 6 5
3 2 1
4-3 registered at 13.65 K Ohms
6-2 registered at 13.87 K Ohms
5-1 registered at 13.78 K Ohms
Primary read 1.3 Ohms on the first pair and .8-.9 Ohms on the second pair. That seems a bit off- but the connectors are not rusted
Thanks for any and all input. The MIL eliminators took care of my other worries, and this code was pending at SZ06, so hopefully once this is fixed it will be the LAST of my issues for just a little while..
