Originally posted by linuxglobal:
Just today after running the belt for almost 300km the check engine light came on.

i got an error of p1381 : Camshaft position timing over advanced (bank 1).

any ideas



I was just thinking, would all of the setup trials cause this problem, there was a time when the belt was offset and the car didnt start and ran rough after a while when it did. Im thinking maybe thats what recorded as an error and it just popped up now as a problem.

I erased the code for now and ill see if it persists. Otherwise the car runs fine and no problems with the belt either. Ive driven through hot weather as well along with non stop trips for about 60km one way.