Originally posted by RogerB:
Well, Contours couldn't put the intake in that location unless we relocated the radiator "catch can" to the driver's side.

I'm not at all sure the S/C unit would fit, but then I'm no expert on the engine bay, either.



Part of the install is to relocate the radiator overflow canister to the driver side, so not an issue. The SC was installed in a Cougar, so the engine bay dimensions should be close to the SAME. The Cougar might even have a slightly lower hood?? I'm no expert either, but it should fit in a Contour just fine.

When this GB first started, I was considering it as an alternative. It seems to be a very nice low cost kit, but because the creator of the kit never seems to post & it's being sold/marketed by a third party, I've been uncomfortable with the whole financial & accountability arrangements so will be taking my project in a different direction. As kits get delivered & installs completed, we will all get more comfortable with them, I'm sure.


Must be that jumbly-wumbly thing happening again.