Just go buy some flat stock steel at Menards/Home Depot etc. Make these into adaptor plates. It works pretty slick and saves time and money. I spent $12 on steel from Menards and made adaptor plates to bolt my Corbeau racing seats into my Camaro using the factory seat brackets.
Place the steel pieces over the bottom of the Jetta seats, mark where the holes are, and then drill accordingly. Then place the steel over the Contour seat brackets and mark the bolt holes, again drill accordingly. Then tada, you have adaptor plates to bolt your Jetta seats to your Contour seat brackets. It works better to actually measure out the distance between the bolt holes on the seats and brackets for an exact fit.
Take some pictures when your done.
-Mike
98 Contour SVT
Toreador Red #49 of 6535 Built on 3/25/97
WR Headers, Borla Cat-Back, Torsen T2 LSD, K&N Short Ram, S-AFC and Focus Shift Tower
85 Camaro
1969 358ci, 97 TA interior, 91 Z28 GrdEfx and Aero Wing 255rwhp
| 
