Originally posted by Goonz SVT:
Originally posted by NVMYSVT:
its worth looking at your wiring to the crankshaft position sensor..





... where is it located?



From Ford CD.
Crankshaft Position Sensor
Removal
1. Disconnect battery ground cable.
2. Raise vehicle on a hoist (or jack up and put on jack stands).
3. On 2.5L engine-equipped vehicles, remove splash shield from RH front fender apron.
4. Disconnect the fuel charging wiring or engine control sensor wiring (depending upon application) from the crankshaft position sensor (CKP sensor).
5. Remove crankshaft position sensor retaining bolt and remove crankshaft position sensor.

Installation
1. Make sure crankshaft position sensor mounting surface is clean. If equipped, make sure that the crankshaft position sensor O-ring is in proper location on crankshaft position sensor.
2. CAUTION: Do not overtighten crankshaft position sensor retaining bolt or damage to the crankshaft position sensor may occur.
Position crankshaft position sensor and install retaining bolt. On 2.0L engine-equipped vehicles, tighten retaining bolt to 6-9 N-m (53-80 lb-in). On 2.5L engine-equipped vehicles, tighten retaining bolt to 8-12 N-m (71-106 lb-in).
3. Properly route fuel charging wiring or engine control sensor wiring (depending upon application) and connect electrical connector to crankshaft position sensor.
4. On 2.5L engine-equipped vehicles, install splash shield. Tighten retaining screws securely.
5. Lower vehicle.
6. Connect battery ground cable.

Picture compliments of Chongo.
Originally posted by chongo:

See if the wires harness is lose. Tough to test it as the PID's on the service cd need the car running.
Autozone sells them for $13.99
CRANKSHAFT POSITION SENSOR
1998 FORD CONTOUR WELLS SU292 3 MO $13.99



"Always do the cheap and easy ones first." 1996 V6 ATX 96K miles