last year i picked up a set of Shmo Shop subframe connectors. of course, it was a PITA to actually get them, but i did. they were $150 + shipping + PITA. we dont know how much ours would cost yet but it wont be more than these were. we'll need to find out how much the steel will cost, and how much our welder will charge. of course, the more that we make, the less the cost will be. since you can't even get these anywhere anymore, besides making your own, i figured id at least offer to these to you guys, if there is enough interest.
these subframe connectors will stiffen up your chassis during cornering. not only that but they will help eliminate squeaks in your car. AND yet another huge benefit is that you can simply slap a jack under any part of the connector and jack your car up! let me put it this way, when i jack up the car behind the front wheel, the rear wheel jacks up with it.
these are tried and true yet apparantly only a few people have them.
i paid only $60 to have them installed (welded) which any decent exhaust shop with a drive-on lift should be able to handle it.
remember, this is
only an interest check at this point. production would likely start after the new year. and please, lets not turn this into a Shmo Shop debate
here are mine. i painted them blue. and NO commenting on my poopy welds
