For those that are unaware of what i'm doing here, this is what i'm looking at producing multiples of. it is a 2-5/8" gauge molded into the dash for a stock look and feel, with easy reading ability. Shown is a 2-5/8" Oil pressureg gauge. I have not done a 2-1/16" yet...so there may be a discount involved for the first person on that one, as it will also be used to make my mold when i'm done with it.
Requirements: You send me your bezel, and gauge you wish to use...i do the rest.
Turnaround: No mroe than a week, i'm doing these n the side after work, so i only spend a cuple hours a day on them.
Cost: $125 shipped....this pod has OVER 8 hours of sanding into it....it flows FLAWLESSLY, believe me, those that have seen it will tell you it's worth it.
Note: This pod eliminates the "off" function of the center vents....but really, who close them anyway?? You'll also have to find a new home for your change.
