Well, today I received my BAT Rear Sway-Bar, and it was instantly taken to the shop where they started bending material to match the design, except much larger diameter, hollow tubing, heat treated, and powdercoated. They are making the poly bushings in-house, along with everything else, thus keeping my final cost low. If more people are interested in this, I can have more produced. I am not doing a group-buy on this, there is no minimum # that needs to be ordered, and I can produce anywhere from 10 to 1000 of these units in the next month.
I will post tonite or tomorrow when I get final design approval from the engineer, and I have final material sizes and estimated cost per unit.
If you're interested, either reply or send me a PM, so I can get some #'s to the shop.
E1
