ok, the mesh is here.
but its not cut yet, that will be happening early next week.
i am going to post what i have for names and stuff.
and all i need you guys to do is let me know if i have made a mistake.
i dont want this post to get out of hand.
alot of questions were asked and answered in the interest check post.
just to clarify:
an SVT set is three pieces of mesh, one piece big enough to do the grill and one piece for each bumper.
the bumper pieces will be rough cut to size and have slots cut out so they can be slid right onto the factory mounting tabs.
$50 shipped.
SE set: 2 pieces of mesh.
one for the grill and one for the lower bumper roughly cut to size.
i DO NOT know how this can be mounted to the bumper easily.
i need to get a closer look at an SE bumper to determine the proper size to cut the mesh.
but as for mounting, that will be left up to you.
i suppose it could be epoxied to the back of the bumper or fiberglassed.
$40 shipped.
GRILL: 1 piece of mesh.
1 piece for the grill
$30 shipped
here goes....
SVT Set:
Goonz SVT
mygameisplatnum
GetLucky151
Redlineracer12
djdanyloz
KingpinSVT
Dtox
zgendron
epattonm
LUCA (special request)
LancasterSVT
2kSVT
CSVT985
Manch-VegasSVT
wp_master
Redlineracer12
lucky13
BoarderPow
SE Set:
brapple
LoCoZsc
I-Dom-In-8
eyevancsu
Custom Set of mesh:
jon_mason14
Interest shown but not sure:
please confirm and tell me what you want for mesh.
NorMich99SE
svt4stv
Snipey
absoluteSVT98
oakuspocus
A-TownSVT
svt2137
SvtEdwardo420
i also have had a few people make special requests.
if you are one of these people please pm me with the details again and title your pm "Elky Mesh Special Request"
i will start cutting mesh as soon as i can.
so please let me know if the info i have above is wrong.
