Contour Enthusiasts Group Archives Forums Modifications Duratec Maintenance PCV Valve Picture

Hey Guys,

I am in the process of cleaning my TB. I bought a PCV Valve to change it out while I'm at it. However, my car doesn't seem to have a PCV Valve. Its like someone took it out and just connected the two ends.

Can someone take a picture so I know how it used to go in there?

Thanks,
Zack

It's directly beneath the linkage bracket, should be two connections on top tee. Bottom fits into large rubber hose.
Be careful since I just did the same and broke the plastic tube that runs along the firewall. See my post at near the bottom of this section.
Unfortunately, the new one from Autozone did not fit properly so I put the old one back in. The old unit looked good, was very clean and the spring was still strong.
I got 110K on mine.

Its the round black thing in the tube in the middle of the picture. It has an attatchment to it with one hose on it and another spot where the hose from the UIM will go. To give you a better sense of it's location, the rusty thing cut off at the top of the picture is where the EGR valve is sitting (the wierd UFO in the back).