Contour Enthusiasts Group Archives Forums General Group Buy Official Steeda Tri-AF/X GB #2

Man guys,

Thanks for being patient with me and Ray. We are working our butts off and I am dealing with my Uncle who just had a massive heart attack. He was in CCU until yesterday and is in ICU today. Hoping to move him to his own room tonight or tomorrow. We were hoping to have around 20 to make this work for everyone. I am thinking that we will close the GB sometime in the middle of next week. With the number we have we will make it work.

Once again thanks for being patient with us as we are up to our eyeballs in work and life at the moment.

Thanks,

Eric

A big thanks to scottd60, Ray and Eric for all their hard work getting this GB going and following through despite all the difficulties. Hope everything goes well with your uncle Eric

best of luck eric, to verify, i have a 98 shifter tower in my car so i need the smaller thicker plate....

you can add me to the list i have a 98 and will need the smaller plate

I am verifying that I am still in and need the smaller, thicker, earlier model plate (for a 98.5).

Still in! Need the 2000 plate.

Ok guys...I received a PM from Ray last night, Eric has had a family situation that he is dealing with. That is why he has not been on-line and not responded to this in a while so please be patient.

What I need from all of you is to have this list verified and updated with the plate type you will need so that we have the proper amount of both type plates we need to complete the GB. This is just a list that I copied from a few pages back so it may not be very accurate so add, remove, update or whatever is necessary to get it right. Be sure to check your shifter tower before you pick the plate you need. You can easily pop off the ring around the boot with a small screwdriver to get a quick look at your shift tower and determine which plate you need.



If the top of your shifter tower looks like this (ignore the shifter part since the Steeda is already installed) YOU WILL NEED THE LARGER 2000 MODEL PLATE.


All others (some 2000, 1999 and older) will need the small plate.

Updated list:

1) path914... verify plate?(99)
2) Speed Demon... small plate (98)
3) papadage... small plate (98)
4) 99SVT... ?
5) dorf tourcon... small plate (98)
6) SvtinAtl... small plate (98)
7) FreeProjectPat... small plate (98)
8) KTPDave... small plate (98)
9) thejms... large plate (2000)
10) Antonio... small plate (99)
11) jshimer23... small plate (99)
12) Morbid... large plate (2000)
13) KingPinSVT... (maybe)
14) Maverick... small plate (98)
15) imnotacop420... small plate (98)
16) gamiller... verify plate? (99 Cougar)
17) rmcd79... small plate (98)
18) rmcd79... verify plate? (99)
19) skillet26... verify plate? (99)

Thanks for your patience.
Scott

could we send money orders? im trying to figure out how i can pull this off. also, i have a 98.5 so i would think i need the fatter plate.

still in and have a 99

Jump on this guys,I bought one from the last GB. Ray and Eric are top notch guys. Any one near Dayton Oh.,I put one in my 2000(made a large plexiglass plate)and have installed a B&M in 98. I have a small plate from the last GB,free to anyone around here that needs one or needs help on the 30 min. install.

2kSVT

Rod