|
|
|
|
Joined: Oct 2003
Posts: 79
CEG\'er
|
OP
CEG\'er
Joined: Oct 2003
Posts: 79 |
where it is located  95 contour v6
|
|
|
|
|
Joined: May 2000
Posts: 21,197
I have no life
|
|
I have no life
Joined: May 2000
Posts: 21,197 |
In the engine compartment on the firewall I think. You can just jump it and count the code flashes.
-'96 SE MTX 3L
-'98 SVT 1,173 of 6,535
-'05 Mazda 6s, loaded, g/f's ride
-Need a 96-00 manual on CD? PM or email me
|
|
|
|
|
Joined: Jun 2002
Posts: 191
CEG\'er
|
|
CEG\'er
Joined: Jun 2002
Posts: 191 |
Its located by the drivers side wheel well at the top. It's clipped in closer to the side panel...well mine was anyway.
'95 Contour SE - MTX
All stock...except for my Canadian Tire cup holder
270,000 kms (April 2004)
 GO BABY GO!
|
|
|
|
|
Joined: Dec 2001
Posts: 6,910
Hard-core CEG'er
|
|
Hard-core CEG'er
Joined: Dec 2001
Posts: 6,910 |
under the hood, on the fender, behind the strut tower. the two plugs are in a plastic clip that is attached to the fender
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd
Official NE-CEG Contour/Mustang Family
|
|
|
|
|
Joined: Aug 2001
Posts: 4,639
Hard-core CEG'er
|
|
Hard-core CEG'er
Joined: Aug 2001
Posts: 4,639 |
how about in the post 98s specifically the svt
Hugo AIM:omegazodiac
95 gl & 99 contour svt #1750/2760
my profile pics stuff for sale
|
|
|
|
|
Joined: May 2002
Posts: 21,653
I have no life
|
|
I have no life
Joined: May 2002
Posts: 21,653 |
The OBD 2 plug (96 and newer vehicles) is located under the driver's side dash, near the fuse box but closer to the driver.
98.5 SVT
91 Escort GT (almost sold)
96 ATX Zetec (i brake to watch you swerve)
FS: SVT rear sway bar
WTB: Very cheap beater
CEG Dragon Run - October 13-15
|
|
|
|
|
Joined: Oct 2003
Posts: 79
CEG\'er
|
|
OP
CEG\'er
Joined: Oct 2003
Posts: 79 |
Thank for the help I found it  .could someone tell the proper way to read code with a voltmeter also the jumper cable has two wires in it(two holes), which wire do I use?
|
|
|
|
|
Joined: Jun 2001
Posts: 2,166
Hard-core CEG\'er
|
|
Hard-core CEG\'er
Joined: Jun 2001
Posts: 2,166 |
Go Here:
http://www.troublecodes.net/Ford/
Or search around the forums. You'll find plenty of info on this.
Also, as recommended on this site, I found that a giant paper clip works as a great jumper wire.
And, you don't actually need the voltmeter as the CEL in your car will flash the codes with the jumper wire in place.
Last edited by zgendron; 10/21/03 08:11 PM.
- Zack
WANTED: T-Red HEATED Side Mirrors
FOR SALE: 4 14" Alum Alloys and Nearly New Avid H4s Tires w/ Center Caps
2000 T-Red SVT
1995 LX V6 MTX (RIP)
|
|
|
|
|
|
|
