Contour Enthusiasts Group Archives Forums General Troubleshooting gauge cluster / speedo cable removal?

Hello all....I am looking to remove the gauge cluster from a 95 contour. The speedo cable is hanging me up. I am trying to get at the warning light bulbs along the bottom of the cluster to replace burnt-outs. It's not my car and I am working without any manuals.....any possible help or info? Thanks.

Welcome onboard.

Should be enough slack to pull cluster back and remove speedo cable. Cable is 2 piece and can also be disconnected in engine compartment close to firewall.

I'll see if I can find an old thread and add via edit.

Edit: gauge cluster w/speedo cable

Here, this should get you started. The 95's might be a little different but I'm sure not much.

Click Here

Click linky, no worky, since FCO inhibits Xlinks.

Are you serious. It works for me. And way go to the forums at http://www.fordcontour.org then scroll down to interior modifications. These are the Indiglo Gauge install instructions. They are not exactly for your car, but should put ypu on the right track.

Help was much appreciated....disconnected at the firewall and removed cluster no problem...thanks again