|
|
Joined: Dec 2001
Posts: 131
CEG\'er
|
OP
CEG\'er
Joined: Dec 2001
Posts: 131 |
Those of you who have changed the pulley, what size did you use and where di you get it? I think fst4dr has done this. Am I correct?
Thanks, Jim
Last edited by JETNBYA; 11/21/02 12:33 AM.
98.5 SVT, Vortech SC, Bassani, Quaiffe, Clutchmasters Stg. 3, H&R's/Konis, BAT 22mm Sway Bar, 17" Momo Arrows, Michelin Pilot Sports, Sparco Front Brace, HPP Rear Brace, PIAA fogs & headlights.
|
|
|
|
|
Joined: May 2000
Posts: 1,020
Hard-core CEG\'er
|
|
Hard-core CEG\'er
Joined: May 2000
Posts: 1,020 |
3.125 is what I am running. (3.33 is what comes with the kit) I got it off of Ebay. You can get them straight from Vortech here.
Just make sure its the 6 rib one.
bumped my boost up to a solid 10 psi at redline.
|
|
|
|
|
Joined: Dec 2001
Posts: 131
CEG\'er
|
|
OP
CEG\'er
Joined: Dec 2001
Posts: 131 |
The Vortech site says does not include retainer assembly. Is that something I already have?
Jim
98.5 SVT, Vortech SC, Bassani, Quaiffe, Clutchmasters Stg. 3, H&R's/Konis, BAT 22mm Sway Bar, 17" Momo Arrows, Michelin Pilot Sports, Sparco Front Brace, HPP Rear Brace, PIAA fogs & headlights.
|
|
|
|
|
Joined: May 2000
Posts: 1,020
Hard-core CEG\'er
|
|
Hard-core CEG\'er
Joined: May 2000
Posts: 1,020 |
You don't need the pulley retainer. I think that is the screw and washer that are holding the one you got on there now.
Its pretty much a swap and play deal. except alot more complicted because of the tight working conditions. Also the pulley doesn't like to come off the shaft to easy. I had to heat it up pretty good with a propane torch before it would budge, then it took some finagling with two screwdrivers to get it off.
|
|
|
|
|
Joined: Dec 2001
Posts: 131
CEG\'er
|
|
OP
CEG\'er
Joined: Dec 2001
Posts: 131 |
Simon,
Thank you so much for the info.
Jim
98.5 SVT, Vortech SC, Bassani, Quaiffe, Clutchmasters Stg. 3, H&R's/Konis, BAT 22mm Sway Bar, 17" Momo Arrows, Michelin Pilot Sports, Sparco Front Brace, HPP Rear Brace, PIAA fogs & headlights.
|
|
|
|
|
