Contour Enthusiasts Group Archives Forums Modifications Wheels & Tires New Hubcentric lightweight Rota wheels in 4x108!!

I've been hawking these a lot w/ the focus peeps, and i'd thought i'd let you all know too (if you didn't already)

I have been working w/ Rota wheel in making special runs of the 4x108 HUBCENTRIC bolt pattern that fits the pre 91 escort/EXP, Tempo, Topaz, Contour, 99 up Cougar, and Focus.

Presently, I have a 16"x7" (13 lbs) slipstream (bronze) and 17"x7.5" attack (steel grey) done and in stock, and the following are on their way as well

15x6.5 slipstream in silver and black (12 lbs)
17x7.5 attack in black w/ polished lip (16 lbs)
17x7.5 subzero in steel grey w/ polished lip (17 lbs)

With the exception of the first run 16" Slipstreams, all wheels are hubcentric to the Ford hub bore - most aftermarket alloy wheels are oversize here to accomodate a larger variety of applications, but Rota was willing to give this a go. I am the exclusive distributor for this wheel.

Prices are as follows:
15" - $112.50 ea ($450 set)
16" - $125.00 ea ($500 set)
17" - $148.75 ea ($595 set)

If you'd like pics besides whats at http://www.rotawheels.com or http://www.imagestation.com/album/?id=4291635661 or want to reserve a set, contact me at zxtuner@hotmail.com

Thanks,
Rob Green

Your album doesn't work and they don't list the slipstream on there website!

-Andy

What are the offset of the 17X7.5 wheels, I'd be interested, but I need offset in the 42mm+ range. . .

Suneil

Damn that is light, are those suckers forged?

The album link is working on my end - it's a little slow to load tho...

Here's a pic of the slipstreams (hope it works):

offset is 40mm for the 15's and 16's, and 45mm for the 17's.

Rob

not forged - they're pressure cast. Actually pretty strong too. I ran over a control arm on the freeway w/ a set w/o any incidence.

the Miata and WRX SCCA crowd have flocked to this wheel quite a bit - and it's held up quite well. I know it meets the JIS and DOT specs.

Rob

Well, the offset is right, so I won't worry about rubbing. I have 13in rotors in the front (Baer Track system), will they fit? They currently fit my Enkei RS5's which are 17X7 with a 40mm offset, should I measure and send you specs? Or do you know off hand if 13in rotors + a heft caliper would fit underneath?

I'm in on these, I just need to figure out what the attacks look like (the website doesn't have them), and figure out what would look best. . .

Suneil

http://www.massimoperformance.com/rota.html

That link to page with better pics

I Would take Bronze or silver Rota attack in 17x7.5!!
If they can custom drill me a set I'LL buy them next week when I get paid!!!
Theu should make battle and circuit 8 too. Well any of those three in bronze or silver will do for me!!

Hey Rob,
These wheels are listed at $550 for a set of 4 at www.massimoperformance.com (or whatever the link is up there). . .

Would you match that?

Suneil