Contour Enthusiasts Group Archives Forums Modifications General Mods Aftermarket electric water sender

All:
I've posted this question on some other boards, but I'd like to hear from the power of the CEG.

Where is the best place to install an Autometer electrical water temp sender. It was suggested to get a y connection where the stock sender is. Is that a good idea? It was also suggested to install the sender in the frost plugs.

Any tips/hints?

TIA!

take a knife cut an hose stick it in there duck tape it back up and call it frankencooler


Micah

A Y split at the stock sender should work fine, plus it's in the water cross over tube which can be easily replaced if you "F" it up beyond repair.