Register Log In

Contour Enthusiasts Group Archives Forums Modifications Duratec Maintenance Pulling Rotor

Print Thread

Pulling Rotor #1640390 09/04/06 08:15 PM
Joined: May 2004 Posts: 3,637 Calgary, Alberta, Canada T Tourige OP Hard-core CEG\'er
OP Tourige Hard-core CEG\'er T Joined: May 2004 Posts: 3,637 Calgary, Alberta, Canada	Well it seems my rotor is going to be a huge PITA to get off. I went ahead and got a gear puller that will probably wourk with the rotors (it fits up and everything) its 3 teird and im HOPING it dosent warp it at all. Now i need to know if its safe to put the middle part (the one tong that works the opposite way) pushing into the axle.. where the axle nut usually is. Can i put any pressure on that, or is it bad for the axle?? 99 TRed Contour SVT # 1853 out of 2760 230.2 WHP @ 6500 237.0 WTR @ 2250 Originally posted by MxRacer: Originally posted by RawBurt: I'll be keeping it to myself, until the time comes. It'll be hard to find. much like your weiner.

Re: Pulling Rotor #1640391 09/04/06 10:32 PM
Joined: May 2004 Posts: 3,637 Calgary, Alberta, Canada T Tourige OP Hard-core CEG\'er
OP Tourige Hard-core CEG\'er T Joined: May 2004 Posts: 3,637 Calgary, Alberta, Canada	nm, got it. 99 TRed Contour SVT # 1853 out of 2760 230.2 WHP @ 6500 237.0 WTR @ 2250 Originally posted by MxRacer: Originally posted by RawBurt: I'll be keeping it to myself, until the time comes. It'll be hard to find. much like your weiner.

Re: Pulling Rotor #1640392 09/05/06 03:38 AM
Joined: Sep 2000 Posts: 4,693 Thousand Oaks, California, USA B Big Jim_dup1 Hard-core CEG'er
Big Jim_dup1 Hard-core CEG'er B Joined: Sep 2000 Posts: 4,693 Thousand Oaks, California, USA	Make sure that you apply some anti-sieze between the hub and rotor so that it will come apart easier next time. Jim Johnson 98 SVT 03 Escape Limited

Moderated by GTO Pete, Lance Kinley_dup1, Ray_dup1

Link Copied to Clipboard

Powered by UBB.threads™ PHP Forum Software 7.7.5