Contour Enthusiasts Group Archives Forums General Troubleshooting NEED HELP ELEC. PROBLEM. CAR HAS NO SPARK

Check Fuses 4, 9 and 30, Relays 6, 11 and 16.

Fuse Diagram

hi and thanx tony, i know i tried the fuses under the dash and the only ones that did not light up the test light was the 7.5 fuses. i tested them by touching the test light tip to both sides of the 7.5 fuses and they did not light up, but visually looked at them before and they looked ok. i will look at them again. but if they are good what next thanx.

Change the ones which did not light up. Fuse 30 is 7.5 amps and is for Engine Management System.

Originally posted by Big Jim:

---

....One of the first rules of troubleshooting is that you fix what you know is wrong and the re-evaluate. ...

---

Edit.
If all broken fuses (confirmed by test light, not "looks fine") are changed and it still does not work, check the connectors behind the fuse boxes. It could have melted.
Read this thread.

will try tony, and thanx again, but did want to say, the black relay for the ignition under the dash. when i pulled it 1 of the metal tabs sticking out thier were 4 tabs. 1 was kind of brown burn spot on it. but did not look too bad just enough to take notice from the color of the rest of the tabs. but wanted to know if you have autozone site for the wiring diagram in case need to run things down to trace for a 95 contour with a manual shift. thanx tony

Click Autozone Wiring Schematic

Possible "Pats" ? not sure if 95's have???
A fault on the PATS which enables the engine to start will be indicated by illuminating the LED continuously for one minute, and then flash the PATS fault code ten times. If the engine cannot be started (disabled by the PATS) the LED will flash fast for one minute, followed by the PATS fault code ten times.

Paul

Codes 11 thru 16 and 21