I read the How-to about installing a keyless entry/alarm. I just got an Autopage RF-405A that I'm trying to get installed on my '96 Mystique. I found the power wire and ground location, and I found the door lock/unlock wires, they were the same colors that were listed, I tested them with my multimeter to verify that they're right. So now I'm confused about the instructions given by Autopage. It has a 6 pin adaptor with the following names:
Brown Unlock Switch N/C (87a)
Blue Unlock Motor COMMON (30)
Violet Unlock N/O (87)
White Lock switch N/C (87a)
Green Lock Motor COMMON (30)
Violet/Red Lock N/O (87)
(The violet and violet/red wires meet at a 20 amp fuse and continue as a single wire)
Do all of those go the relay that was provided? And if so, there's no wire coming from the pin labeled '87' on the relay. Do I not connect the violets to anything on the relay? Also, what wires do I connect from the unit to the door unlock wires? And does something connect to the thick green (+12V for ignition 'on') wire?
Besides what I've already listed, the rest of the wires are this:
Trunk trigger - input
Positive trigger + input
Ignition input
Negative trigger - input
Starter Interrupt output
Priority door unlock
3rd channel output
2nd channel output
Dome light output
and
Green + light flash
Black - main system ground
Blue + siren output
Red 12V + main power
Blue/Black - horn output
And what wires should I be looking for for light flash, dome light, and horn?
Thanks!
Mikael
