Ok, this has been somewhat beat to death I know, but searching didn't answer this question. In the Haynes manual its has the Oil Pressure sender adjacent to the oil filter at the front of the block. If I hook my tubing up there will it read accurate? Or should I go from the head?
The "Bluer Tour" 1998.5 SVTour
R.I.P. 2000 ATX Tour SE
read from the stock oil pressure sensor loacation as everyone says that reading from the head is not accurate, although that is where my electric oil pressure quage is at the moment , that is until I relocate my oil filter
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd
Official NE-CEG Contour/Mustang Family
There is information in the archives that answeres this questions.
Behind the A/C compressor (where the stock oil sending unit is), is an allen head plug in the lower portion of the plug. Remove and install mechnical gauge tubing, etc. here.