Contour Enthusiasts Group Archives Forums Modifications Duratec Maintenance Sharing the pain...

Originally posted by todras:

---

....Building harnesses in a 'cleared new jungle' site in the far east, shipping them to Germany then on to USA tends to pick up a bit of
moisture!..

---

Originally posted by todras:

---

Originally posted by CSVT#49:

---

I would wish this task apon no one...

removing the rear main wiring harness so I can rewire the damn thing because some stupid electrical engineer couldn't figure out he needed to have a different insulation on the cam and crank sensor wires.

---

.....wrong, Karl K (the electrical eng. who released the Contour wiring) did not make them, the issue was caused by the supplier AMERICAN Yazaki.....Building harnesses in a 'cleared new jungle' site in the far east, shipping them to Germany then on to USA tends to pick up a bit of
moisture!....'can you spell 'outsourcing!!!!!!

---

Teeheee My dad used to work for Yazaki :-p. Though he had nothing to do with the [censored] harness', Marketing doesnt deal with creation .

Originally posted by todras:

---

.....wrong, Karl K (the electrical eng. who released the Contour wiring) did not make them, the issue was caused by the supplier AMERICAN Yazaki.....Building harnesses in a 'cleared new jungle' site in the far east, shipping them to Germany then on to USA tends to pick up a bit of
moisture!....'can you spell 'outsourcing!!!!!!

---