|
|
Joined: Sep 2000
Posts: 7,025
Hard-core CEG'er
|
OP
Hard-core CEG'er
Joined: Sep 2000
Posts: 7,025 |
All the time I see, "my zetec runs on the A or L in NORMAL." Every person over on automotiveforums.com that posts a problem pretty much retains to this. Whats the deal?
Jim Hahn
1996 T-Red Contour SE Reborn 4/6/04
3.0L swap and Arizona Dyno Chip Turbo Kit
364 whp, 410 wtq @ 4,700 rpm
|
|
|
|
Joined: Jan 2005
Posts: 453
CEG\'er
|
CEG\'er
Joined: Jan 2005
Posts: 453 |
Good question, and let me tell you they are highly accurate gauges, and if I ever catch mine edging past the L or dropping below the N during normal driving I'll know somethings up
|
|
|
|
Joined: Aug 2001
Posts: 17,248
CEG road warrior
|
CEG road warrior
Joined: Aug 2001
Posts: 17,248 |
Mine sits right in the middle (between O and R). Never changed from the day I got it. I'm thinking that the cause may be the cooling system not being flushed/ maintained.
Hector
2003 Rally Red Mitsubishi Evolution VIII
257HP/259TQ
2005 Lapis Blue Mazda 6s
RET: 00 Cabernet Red Ford Contour Zetec ATX SUPERCHARGED
160HP/141TQ
|
|
|
|
Joined: Jul 2005
Posts: 52
CEG\'er
|
CEG\'er
Joined: Jul 2005
Posts: 52 |
my gauge is always between the a and l. on a good day its on the o or goes up the l then back to o
|
|
|
|
Joined: Jan 2005
Posts: 453
CEG\'er
|
CEG\'er
Joined: Jan 2005
Posts: 453 |
Mine used to sometimes not work at all, I think maybe there's a bad connection. But usually it works, and the needle hangs around the RM or maybe the A. -Peter
|
|
|
|
Joined: Sep 2002
Posts: 1,957
Hard-core CEG'er
|
Hard-core CEG'er
Joined: Sep 2002
Posts: 1,957 |
whats with all these letter like a and l mine doesnt have letters. But it does stay towards the middle or colder.
NEED AN SVT REAR BUMPER!!! pm me
|
|
|
|
Joined: Aug 2000
Posts: 8,301
Addicted CEG\'er
|
Addicted CEG\'er
Joined: Aug 2000
Posts: 8,301 |
Mine always sits just to the left of the middle.
-Ken V.
1998.5 SE Praire Tan Zetec ATX
psycho_bass@hotmail.com
Roush springs Roush rear sway bar BAT struts 17" Millie Miglia HT3 and a ton of subtle asthetic mods
|
|
|
|
Joined: Oct 2003
Posts: 5,143
Addicted CEG\'er
|
Addicted CEG\'er
Joined: Oct 2003
Posts: 5,143 |
Originally posted by lsneo: whats with all these letter like a and l mine doesnt have letters. But it does stay towards the middle or colder.
Some of the Gauge clusters didnt have the "Normal" print in the temp gauge... usualy on the 98-00 No Tach clusters.
98 Corolla LE 1.8L DOHC 1ZZFE
TEIN H.Tech Springs
Tokico HP series Struts
Short ram air intake
Tsudo Axel Back Exhaust
... if a jelly fish stung me.. would you pee on the wound?
|
|
|
|
Joined: Dec 2001
Posts: 6,910
Hard-core CEG'er
|
Hard-core CEG'er
Joined: Dec 2001
Posts: 6,910 |
mine normally sits right at R/M in normal, on hot days in traffic it will get to L but that is when the fan kicks in
now of course the duratec just sits steady all day
maybe it has something to do with the design of the system and the one vs two fans to help with the cooling
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd
Official NE-CEG Contour/Mustang Family
|
|
|
|
Joined: Jul 2003
Posts: 3,816
Hard-core CEG\'er
|
Hard-core CEG\'er
Joined: Jul 2003
Posts: 3,816 |
My old Zetec ran between the M and A when I first got it, then after changing the water pump (preventive while doing the timing belt), did the same until it overheated one day and the timing belt cover was spewing with coolant out of every crack. I guess the new WP had a leak... only overheated once after that (summer with the A/C on delivering pizza), but it would run just under the red to just on the red (which is when the fans would kick in). I figure the WP had a small leak and wasn't able to pressurize the system, which caused it to run real hot.
So yeah, I was always on the edge of overheating the 1.5 years I had it after the WP change.
|
|
|
|
|
|